Propeller Shaft - Clicking Noise

NO: 03-05-98

GROUP: Axle And Propshafts

DATE: Jul. 31, 1998

SUBJECT:

Universal Joint Noise

MODELS:

1998 (DN) Durango
1998 (XJ) Cherokee
1998 (ZJ) Grand Cherokee
1998 (TJ) Wrangler

SYMPTOM/CONDITION:

A clicking noise may be present when changing from a forward gear to reverse. This noise may be due to poor fitting universal joint retaining straps. The straps may be located on either the front or rear prop shaft depending on model and build configuration.

DIAGNOSIS:

If the condition is present, check the vehicle build date. If the vehicle was built between 3/23/98 and 4/06/98 (MDH 0323XX and 0406XX), perform the Repair Procedure.

PARTS REQUIRED:

2 J3240553 Strap
4 J4006928 Screw

REPAIR PROCEDURE:

This bulletin involves replacing the universal joint strap and attaching screws.

1. Raise the vehicle on a hoist.

2. Remove the universal joint straps. Discard the straps and retaining screws.

3. Install the new straps and attaching screws, P/N J3240553 & J4006928. Tighten the screws to 19 Nm (14 ft. lbs.).

4. Lower the vehicle.

POLICY: Reimbursable within the provisions of the warranty.

TIME ALLOWANCE:

Labor Operation No:

Two Wheel Drive Models
16-30-04-90 0.2 Hrs.

Four Wheel Drive Models
16-30-04-91 0.3 Hrs.

FAILURE CODE: P8 - New Part