Lock Key Cylinder

Ignition Lock Cylinder Detents:

The lock cylinder is inserted in the end of the housing opposite the ignition switch. The ignition key rotates the cylinder to 5 different detentes:
- Accessory
- Off (lock)
- Unlock
- On/Run
- Start

If the vehicle has a column shifter, install a new interlock cassette as outlined under "Ignition Interlock Service." If the vehicle has a floor shift, adjust the interlock cable as outlined under "Ignition Interlock Service."
1. Disarm airbag as outlined under "Precautions."
2. Disconnect battery ground cable.
3. Remove tilt lever.
4. Remove upper and lower column covers.

Lock Cylinder Removal:

5. Turn ignition key to Run position then depress the lock cylinder retaining tab and slide the cylinder out of the housing.



INSTALLATION
1. Install key in lock cylinder. Thrn key to run position (retaining tab on lock cylinder can be depressed).






2. The shaft at the end of the lock cylinder aligns with the socket in the end of the housing. To align the socket with the lock cylinder, ensure the socket is in the Run position






3. Align the lock cylinder with the grooves in the housing. Slide the lock cylinder into the housing until the tab sticks through the opening in the housing
4. Turn key to Off position. Remove key.
5. If the vehicle has column shift and a new lock cylinder was used, install and adjust a new interlock cassette. Refer to Ignition Interlock in this section. If the vehicle has a floor shift, adjust the interlock cable when the lock cylinder is replaced.
6. Install upper and lower cover on steering column.
7. Install tilt lever.
8. Connect negative cable to battery.