Steering Column - Squeaking/Creaking Sound
NUMBER: 19-04-00GROUP: Steering
DATE: JUNE 9, 2000
SUBJECT:
Squeaking/Creaking Sound In Steering Column While Turning
MODELS:
1997 - 2000 (AN) DAKOTA
1994 - 2000 (BR/BE) RAM TRUCK
1998 - 2000 (R1) DAKOTA (INTERNATIONAL MARKETS)
OVERVIEW:
This bulletin involves installing new lock housing attaching screws.
NOTE:
THIS BULLETIN APPLIES TO VEHICLES EQUIPPED WITH NON-TILT STEERING COLUMNS.
SYMPTOM/CONDITION:
A squeaking/creaking sound may be heard coming from the area of the steering wheel while turning. The sound is associated with rotation of the steering wheel or may be heard while going over bumps in the road.
DIAGNOSIS:
1. Start the engine and center the steering wheel.
2. Rotate the steering wheel to the extreme right and then to the extreme left while monitoring for the squeaking/creaking sound.
3. If a squeaking/creaking sound can be heard coming from the area of the steering wheel, perform the Repair Procedure.
PARTS REQUIRED:
5 06506514AA Screw, Non-Tilt Lock Housing
REPAIR PROCEDURE:
THIS REPAIR IS COMPATIBLE WITH DAIMLERCHRYSLER'S MOBILE SERVICE PROGRAM AND DOES NOT REQUIRE HOISTS OR OTHER FULL SERVICE FACILITY SPECIAL EQUIPMENT.
1. Remove the three screws that secure the lower edge of the steering column opening cover to the lower instrument panel reinforcement.
2. Using a trim stick or another suitable wide-bladed tool, gently pry the upper edge of the steering column opening cover. Pry just below the cluster bezel on each side of the steering column away from the instrument panel far enough to disengage the snap clip retainers from the receptacles in the instrument panel.
3. Remove the steering column opening cover from the instrument panel.
4. Loosen the steering column mounting nuts.
Figure 1:
5. Remove the upper and lower shrouds and covers (4 pieces)(Figure 1).
6. Disconnect the wiper switch wiring harness connector.
Figure 2:
7. Remove screw A and replace with new screw, p/n 06506514AA, and tighten to 9 N.m (85 in. lbs.). See Figure 2 for screw identification.
CAUTION:
REMOVE ONLY ONE SCREW AT A TIME.
8. Repeat step 7 for screws B, C, D, and E respectively.
9. Connect the wiper switch wiring harness connector.
10. Install the upper and lower steering column shrouds to steering column. Tighten screws to 2 N.m (17 in. lbs.).
11. Tighten the steering column mounting nuts to 12 N.m (105 in. lbs.).
12. Position the steering column opening cover to the instrument panel.
13. Align snap clip retainers on the steering column opening cover with the receptacles in the instrument panel.
14. Press firmly on the steering column opening cover over the snap clip locations until each of the snap clips fully engaged in its receptacle.
15. Install and tighten the three screws that secure the lower edge of the steering column opening cover to the lower instrument panel reinforcement. Tighten the screws to 2.2 N.m (20 in. lbs.).
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No: 19-20-83-97 0.5 Hrs.
FAILURE CODE: P8 - New Part