Turn Signal Flasher: Service and Repair

REMOVAL AND INSTALLATION

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIRBAGS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIR-BAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

1. Disconnect and isolate the battery negative cable.
2. Remove the end cap from the driver side end of the instrument panel. Refer to Instrument Panel Gauges and Warning Systems/Instrument Panel/Instrument Panel End Cap Replacement.

Junction Block:

3. Unplug the combination flasher from the junction block.
4. Install the combination flasher by aligning the flasher terminals with the cavities in the junction block and pushing the flasher firmly into place.
5. Connect the battery negative cable.
6. Test the flasher operation.
7. Reinstall the end cap on the instrument panel. Refer to Instrument Panel Gauges and Warning Systems/Instrument Panel/Instrument Panel End Cap Replacement.