46RE (A518) 4-Speed

REMOVAL
1. Raise vehicle.
2. Mark propeller shaft and axle yoke for alignment reference.
3. Disconnect and remove propeller shaft.

Removing Overdrive Housing Yoke Seal:

4. Remove old seal with Seal Remover C-3985-B from overdrive housing.

INSTALLATION
1. Place seal in position on overdrive housing.

Installing Overdrive Housing Yoke:

2. Drive seal into overdrive housing with Seal Installer C-3995-A.
3. Carefully guide propeller shaft slip yoke into housing and onto output shaft splines. Align marks