Wiper Motor: Service and Repair

REMOVAL
1. Remove the drive link from the wiper motor crank arm. See Wiper Linkage and Pivot Replacement for the procedures.
2. Disconnect and isolate the battery negative cable.

Wiper Motor Remove/Install:

3. Unplug the wire harness connector from the wiper motor.
4. Remove the three screws that secure the wiper motor to the cowl plenum panel reinforcement.
5. Remove the wiper motor from the cowl plenum panel.
6. Reverse the removal procedures to install. Tighten the mounting screws to 11.8 N.m (105 in. lbs.).