Removal and Installation

CYLINDER HEAD COVER

Cylinder Head Cover Gasket:

NOTE: A steel backed silicon gasket is used with the cylinder head cover. This gasket can be used again.

REMOVAL
1. Disconnect the negative cable from the battery.
2. Disconnect closed ventilation system and evaporation control system from cylinder head cover.
3. Remove cylinder head cover and gasket. The gasket may be used again.

CLEANING
Clean cylinder head cover gasket surface. Clean head rail, if necessary.

INSTALLATION
1. The cylinder head cover gasket can. be used again. Install the gasket onto the head rail..
2. Position the cylinder head cover onto the gasket. Tighten the bolts to 11 Nm (95 inch lbs.) torque.
3. Install closed crankcase ventilation system and evaporation control system.
4. Connect the negative cable to the battery.