Headlamp Control Module: Service and Repair

The headlamp module contains the park/turn signal, low and high-beam lamps. when a headlamp module is replaced, the headlamp alignment must be adjusted. Refer to headlamp alignment procedures.

REMOVAL
1. Remove front bumper fascia as necessary to gain access to bottom of headlamp.

Headlamp Module:

2. Remove nuts holding headlamp to radiator support panel.
3. Remove nut holding headlamp to front frame rail bracket.
4. Disengage wire connector from back of headlamp.
5. Separate headlamp from vehicle.

INSTALLATION
1. Position headlamp to vehicle.
2. Engage wire connector to back of headlamp.
3. Install nut holding headlamp to front frame rail bracket.
4. Install nuts holding headlamp to radiator support panel.
5. Install front bumper fascia as necessary.