Timing Belt

Timing Belt Covers:

1. Remove the upper front outer timing belt cover by loosening the three attaching bolts.
2. Inspect both sides of the timing belt drive & back. Replace belt if any of the following conditions exist:
^ Rubber back side is glossy, hardened back without resilience and leaves no indent when pressed with fingernail.
^ Cracks on rubber back.
^ Cracks or peeling of canvas.
^ Cracks on rib root.
^ Missing teeth.

Timing Belt Inspection:

^ The sides are normal if they are sharp as if cut by a knife.

NOTE: If none of the above conditions are seen on the belt, the belt cover can be installed.