Message Center

REMOVAL

Battery Negative Cable:

1. Disconnect and isolate the battery negative cable.
2. Remove A-pillar trim panel.
3. Remove instrument panel top cover. Refer to Instrument Panel Top Cover Replacement.
4. Disconnect the wire connector from back of message center
5. Remove screws holding message center to instrument panel top cover.
6. Remove message center from instrument panel top cover.

INSTALLATION
1. Place message center in position on top cover.
2. Install screws to hold message center to instrument panel top cover.
3. Connect wire connector into back of message center.
4. Install instrument panel top cover.
5. Install A-pillar trim.