Do you have access to Mitchell1 Prodemand? If you are willing to share user/password (we can pay $250), please get in contact with us ASAP: email operation-charm [[at]] tuta.io or click to submit anonymously. (I know, we said we wouldn't ask any more...but it's important!)
Distributor Drive Bushing Removal and Installation
REMOVAL1. Remove distributor.
2. Remove the intake manifold.
Distributor Driveshaft Bushing Removal:
3. Insert Distributor Drive Shaft Bushing Puller Tool C-3052 into old bushing and thread down until a tight fit is obtained.
4. Hold puller screw and tighten puller nut until bushing is removed.
INSTALLATION
1. Slide new bushing over burnishing end of Distributor Drive Shaft Bushing Driver/Burnisher Tool C-3053. Insert the tool and bushing into the bore.
Distributor Driveshaft Bushing Installation:
2. Drive bushing and tool into position, using a hammer.
Burnishing Distributor Driveshaft Bushing:
3. As the burnisher is pulled through the bushing, the bushing is expanded tight in the block and burnished to correct size. DO NOT ream this bushing.
CAUTION: This procedure MUST be followed when installing a new bushing or seizure to shaft may occur.
4. Install the intake manifold.