Removal and Installation

REMOVAL
1. Disconnect the battery negative cable.
2. Disconnect closed ventilation system and evaporation control system from cylinder head cover. If removing the driver's side cover, remove the engine oil fill tube.
3. Remove cylinder head cover and gasket. The gasket may be used again.

INSTALLATION
1. The cylinder head cover gasket can be used again. Install the gasket onto the head rail.
2. Position the cylinder head cover onto the gasket. Tighten the bolts to 11 Nm (95 inch lbs.) torque.
3. Install closed crankcase ventilation system and evaporation control system. Install the engine oil filler tube (if removed).
4. Connect the battery negative cable.