Remote Switch: Service and Repair

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIRBAGS AND SEAT BELTS/AIRBAGS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the driver side airbag module from the steering wheel.
3. Remove the speed control switch located on the same side of the steering wheel as the [1][2]remote radio switch that is being serviced.

Remote Radio Switches Remove/Install:

4. Disconnect the steering wheel wire harness connector from the connector receptacle of the [1][2]remote radio switch.
5. Disengage the four [1][2]remote radio switch latches that secure the switch to the inside of the mounting hole in the steering wheel rear trim cover.
6. From the outside of the steering wheel rear trim cover, remove the [1][2]remote radio switch from the trim cover mounting hole.

INSTALLATION
1. Position the [1][2]remote radio switch to the mounting hole on the outside of the steering wheel rear trim cover. Be certain that the connector receptacle is oriented toward the bottom of the switch and pointed toward the center of the steering wheel.
2. Press firmly and evenly on the [1][2]remote radio switch until each of the switch latches is fully engaged in the mounting hole of the steering wheel rear trim cover,
3. Reconnect the steering wheel wire harness connector to the connector receptacle of the [1][2]remote radio switch.
4. Install the speed control switch onto the steering wheel.
5. Install the driver side airbag module onto the steering wheel.
6. Reconnect the battery negative cable.