Turn Signal Flasher: Service and Repair

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIRBAGS AND SEAT BELTS/AIRBAGS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the steering column opening cover from the instrument panel.

Combination Flasher Remove/Install:

3. Reach through the outboard side of the steering column opening in the instrument panel to access the relay and fuse block on the back of the junction block.
4. Refer to Fuse/Fuse Block.
5. Remove the combination flasher from the relay and fuse block.

INSTALLATION
1. Refer to Fuse/Fuse Block
2. Position the combination flasher in the proper receptacle in the relay and fuse block.
3. Align the combination flasher terminals with the terminal cavities in the relay and fuse block receptacle.
4. Push in firmly on the combination flasher until the terminals are fully seated in the terminal cavities in the relay and fuse block receptacle.
5. Install the steering column opening cover onto the instrument panel.
6. Reconnect the battery negative cable.