Transmission Mount: Service and Repair

The content of this article reflects the changes called out by TSB 26-04-00.

REMOVAL
1. Disconnect the negative cable from the battery.
2. Raise the vehicle on a hoist.
3. Support the transmission with a transmission jack.





Fig. 39

4. Remove stud nuts holding the insulator to the crossmember (Fig. 39).
5. Raise rear of transmission SLIGHTLY.
6. Remove bolts holding the insulator to the insulator bracket. Remove the insulator.

INSTALLATION
1. If the insulator bracket was removed, install the bracket to the transmission. Tighten the bolts to 68 Nm (50 ft. lbs.) torque.
2. Install the bolts holding insulator to insulator bracket. Tighten the bolts to 28 Nm (250 inch lbs.) torque.
3. Lower rear of transmission while aligning the insulator studs into the mounting support bracket. Install stud nuts and tighten to 68 Nm (50 ft. lbs.) torque.
4. Remove the transmission jack.
5. Lower the vehicle.
6. Connect the negative cable to the battery.