NV5600 Transmission
REMOVAL1. On 4X2 vehicles, remove the propeller shaft.
2. On 4X4 vehicles, remove the transfer case.
3. On 4X2 vehicles, remove extension housing seal with a suitable pry tool or a slide hammer mounted screw.
4. On 4X4 vehicles, use a suitable pry tool, or a slide hammer mounted screw, to remove the adapter housing seal.
Fig. 16:
5. Remove the extension housing bushing with Remover 8155 (Fig. 16).
INSTALLATION
Fig. 17:
1. Install the extension housing bushing with Installer 8156 (Fig. 17) and Handle C-4171.
Fig. 18:
2. On 4X2 transmissions, install the extension housing seal with Installer 8154 (Fig. 18) and Handle C-4171.
NOTE: Be sure that the drain hole located in the dust boot portion of the seal is facing downward (toward the ground) when installed.
3. On 4X4 transmissions, install the adapter housing seal with Installer C-3860-A and Handle C-4171.
4. Install transfer case, if necessary, and propeller shaft(s).