Glass Run Channel

GLASS RUN CHANNEL

REMOVAL

1. Remove the window regulator.

Fig. 3:

Fig. 4:

2. Remove the bottom screws and loosen the top screws from bolt channels. (Fig. 3) and (Fig. 4)
3. Slide the channels up to disengage from the keyhole slots.
4. Separate the glass run weatherstrip from the channel and remove the channels.

INSTALLATION

1. Position the run channels into the door and engage the upper screws into the keyhole slots.
2. Install the lower screws and tighten to 10 N.m (89 in.lbs).
3. Tighten the upper screws to 10 N.m (89 in.lbs).
4. Stuff the glass run weatherstrip into the channels.
5. Verify correct window operation.
6. Install the window regulator.