Ignition Coil: Service and Repair

The ignition coil is an epoxy filled type. If the coil is replaced, it must be replaced with the same type.

REMOVAL

Ignition Coil:

The coil is mounted to a bracket that is bolted to the front of the right engine cylinder head. This bracket is also used to mount the automatic belt tensioner.
1. Disconnect the wiring and secondary cable from the ignition coil.

WARNING: DO NOT REMOVE THE COIL MOUNTING BRACKET-TO-CYLINDER HEAD MOUNTING BOLTS. THE COIL MOUNTING BRACKET IS UNDER ACCESSORY DRIVE BELT TENSION. IF THIS BRACKET IS TO BE REMOVED FOR ANY REASON, ALL BELT TENSION MUST FIRST BE RELIEVED.

2. Remove ignition coil from coil mounting bracket (two bolts).

INSTALLATION
1. Install the ignition coil to coil bracket. If nuts and bolts are used to secure coil to coil bracket, tighten to 11 Nm (100 in. lbs.) torque. If the coil mounting bracket has been tapped for coil mounting bolts, tighten bolts to 5 Nm (50 in. lbs.) torque.
2. Connect all wiring to ignition coil.