Brake Pad: Service and Repair

If brake shoes are to be replaced, remove 1/4 of the fluid from master cylinder with suction gun.

REMOVAL
1. Raise and support vehicle.
2. Remove front wheel and tire assemblies.
3. Remove caliper mounting bolts.






4. Remove caliper by tilting the top up and off the caliper adapter.

NOTE: Do not allow brake hose to support caliper assembly.






5. Remove inboard brake shoe from the caliper adapter.






6. Remove outboard brake shoe from caliper adapter).

Top Anti-Rattle Spring:

7. Remove the anti-rattle springs from the caliper adapter.

NOTE: Anti-rattle springs are not interchangeable.

INSTALLATION
1. Bottom pistons in caliper bore with C-clamp. Place an old brake shoe between a C-clamp and caliper piston.
2. Clean caliper mounting adapter and anti-rattle springs.
3. Lubricate anti-rattle springs with Mopar brake grease.
4. Install anti-rattle springs.

NOTE: Anti-rattle springs are not interchangeable.

5. Install inboard brake shoe in adapter.
6. Install outboard brake shoe in adapter.
7. Tilt the bottom of the caliper over rotor and under adapter. Then push the top of the caliper down onto the adapter.
8. Install caliper mounting bolts and tighten to 33 Nm (24 ft. lbs.).
9. Install wheel and tire assemblies and lower vehicle.
10. Apply brakes several times to seat caliper pistons and brake shoes and obtain firm pedal.
11. Top off master cylinder fluid level.