LDP Monitor Verification Test VER-6A

LDP MONITOR VERIFICATION TEST VER-6A

Applicability - 3.9L V-6
5.2L V-8
5.9L V-8 Light/Heavy Duty
8.0L V-10 Medium/Heavy Duty

LDP Monitor Verification
Use this test to verify that the LDP monitor symptom has been repaired and that the vehicle can be returned to the customer.

Note: If the PCM has been replaced, the VIN and SRI mileage must be programmed into the PCM or a DTC will be set in the ABS controller and the Airbag module.

If the vehicle is equipped with SKIM, Secret Key data must be updated to enable starting. Refer to the appropriate service information as necessary.

1. Inspect the vehicle to ensure that all components related to the repair are connected properly.

2. If any other DTC is present, refer to the symptom list for further diagnostic testing procedures.

3. With the DRB III, perform the LDP Monitor Test. Follow the instructions on the DRB III screen.

4. If the DTC resets, or the OBD II monitor fails after running, or if any other symptom or DTC is present, return to the symptom list and perform the appropriate diagnostic testing procedures. Refer to any Technical Service Bulletins that may apply.

5. If the monitor runs and the test does not fail, the condition is no longer present.

6. If there are no DTC's and all components are functioning properly, the repair is complete.