Sunglasses Storage Bin Replacement

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the overhead console from the headliner. Refer to Overhead Console in the Removal and Installation for the procedures.
3. Remove the four screws that secure the reading and courtesy lamp housing to the back side of the overhead console housing. Move the lamp housing aside as needed for access to the pivot latches that are integral to the overhead console housing for the sunglasses storage bin pivot pins.
4. Open the sunglasses storage bin.
5. From the back side of the of the overhead console housing, gently pry one of the pivot latches forward while pulling the sunglasses storage bin pivot arm rearward until the pivot pin is disengaged from the latch. Repeat this step to disengage the second pivot pin from its pivot latch.
6. From the face side of the overhead console housing, remove the sunglasses storage bin from the overhead console.

INSTALLATION
1. From the face side of the overhead console housing, position the sunglasses storage bin pivot arms through the openings in the front of the storage bin housing in the overhead console.
2. From the back side of the of the overhead console housing, align one of the pivot pins of the sunglasses storage bin with the pivot latch integral to the overhead console housing. Press the pivot arm forward until the pivot pin is engaged in the latch. Repeat this step to engage the second pivot pin with its pivot latch.
3. Close the sunglasses storage bin.
4. Position the reading and courtesy lamp housing to the back side of the overhead console housing. Install and tighten the four screws that secure the lamp housing to the back of the overhead console housing. Tighten the screws to 2.2 Nm (20 in. lbs.).
5. Install the overhead console onto the headliner. Refer to Overhead Console in the Removal and Installation for the procedures.
6. Reconnect the battery negative cable.