Rear Cab Back Panel Trim

REAR CAB BACK PANEL TRIM

REMOVAL

1. Remove the child seat tethers, if equipped.

Fig. 15:

2. Remove the screws and remove the utility hooks/bin latch, if equipped. (Fig. 15)
3. Using a trim stick C-4755 or equivalent, remove the center seat belt trim bezel, if equipped.
4. On quad cab models, remove the left lower c-pillar trim panel. Refer to Trim Panel.
5. On standard cab models, remove the left lower b-pillar trim panel. Refer to Trim Panel.

Fig. 16:

Fig. 17:

6. Remove the push pin fasteners, if equipped, and remove the back panel trim. (Fig. 16) or (Fig. 17)

INSTALLATION

1. Position the back panel trim behind the right pillar trim.
2. Route the center belt and trim bezel through the back panel, if equipped.
3. On standard cab models, install the left lower b-pillar trim panel.
4. On quad cab models, install the left lower c-pillar trim panel.
5. Position the center belt trim bezel, if equipped, and seat the attachment clips fully.
6. Install the utility hooks/bin latch and screws, if equipped.
7. Install the child seat tethers, if equipped.