Alignment Link/Coil Suspension

OVERVIEW
Before each alignment reading the vehicle should be jounced (rear first, then front). Grasp each bumper at the center and jounce the vehicle up and down several times. Always release the bumper in the down position. Set the front end alignment to specifications while the vehicle is in its NORMALLY LOADED CONDITION.

CAMBER
The wheel camber angle is preset and is not adjustable.

CASTER
Check the caster of the front axle for correct angle. Be sure the axle is not bent or twisted. Road test the vehicle and make left and right turn. Observe the steering wheel return-to-center position. Low caster will cause poor steering wheel returnability.






Caster can be adjusted by rotating the cams on the lower suspension arm. Refer to the Alignment Specification for the correct setting.

TOE POSITION

The wheel toe position adjustment should be the final adjustment.

1. Start the engine and turn wheels both ways before straightening the wheels. Center and Secure the steering wheel and turn off engine.
2. Loosen the adjustment sleeve clamp bolts.
3. Adjust the right wheel toe position with the drag link. Turn the sleeve until the right wheel is at the correct TOE-IN position. Position clamp bolts to their original position and tighten to specifications. Make sure the toe setting does not change during clamp tightening.
4. Adjust left wheel toe position with tie rod at left knuckle. Turn the sleeve until the left wheel is at the correct TOE-IN position. Position clamp bolts to their original position and tighten to specifications. Make sure the toe setting does not change during clamp tightening.
5. Verify the right toe setting.