Glass Run Channel

GLASS RUN CHANNEL

REMOVAL

1. Raise glass into the full up position.
2. Remove the waterdam. Refer to front door panel.

FRONT RUN CHANNEL

1. Remove the window regulator.

Fig. 4:

2. Loosen the front run channel screws, slide up and disengage from the door. (Fig. 4)
3. Separate the glass run weatherstrip from the channel and remove the front channel.

REAR RUN CHANNEL

Fig. 5:

1. On standard cab models, remove the screws from the side of the door. (Fig. 5)

Fig. 6:

2. On quad cab models, remove the lower screw from the side of the door, loosen the upper screw and disengage from the door. (Fig. 6)
3. Separate the glass run weatherstrip from the rear channel and remove the channel.

INSTALLATION

FRONT RUN CHANNEL

1. Install the channel, position the screws in the door panel slots and slide into place.
2. Tighten the screws to 10 N.m (89 in.lbs).
3. Install the window regulator.

REAR RUN CHANNEL

1. On quad cab models, install the channel and slide the upper screw into the slot.
2. Install the lower screw and tighten both upper and lower screws to 10 N.m (89 in.lbs).
3. On standard cab models, install the channel and install the screws.
4. Tighten the screws to 10 N.m (89 in.lbs).

BOTH CHANNELS

1. Stuff the glass run weatherstrip into the channels.
2. Verify correct window operation.
3. Install the waterdam.