Window Regulator - Manual

WINDOW REGULATOR - MANUAL

REMOVAL

1. Remove the waterdam. Refer to Rear Door Panel.

Fig. 11:

2. Reinstall the window handle and raise the window to the position shown and remove the nuts. (Fig. 11)

Fig. 13:

3. Remove the stabilizer nuts. (Fig. 13)
4. Disengage the door glass from the regulator lift plate and position into the full up position.
5. Secure the glass in the up position using a wood wedge or equivalent.
6. Lower the regulator.
7. Remove the two back regulator bolts and loosen the front two.
8. Slide the regulator up and out of the keyhole slots in the door panel.
9. Remove the regulator through the hole in the inner door panel.

INSTALLATION

1. Install the regulator through the hole in the inner door panel.
2. Position the regulator bolts into the keyhole slots and slide into place.
3. Install the back regulator bolts and tighten all four to 10 N.m (89 in.lbs).
4. Position the stabilizer, install the nuts and tighten to 10 N.m (89 in.lbs).
5. Using the window handle raise the regulator to the position shown in (Fig. 11).
6. Remove the glass support and connect to the regulator lift plate.
7. Install the glass nuts and tighten to 10 N.m (89 in.lbs).
8. Disconnect the window switch and install into the door trim panel.
9. Using the window handle raise the regulator to the position shown in.