Window Regulator - Power

WINDOW REGULATOR - POWER

REMOVAL

1. Remove the waterdam.
2. Remove the window switch from the door trim panel and reconnect it to the door wire harness.

Fig. 11:

3. Raise the window to the position shown and remove the two nuts attaching the glass to the window regulator. (Fig. 11)
4. Remove the stabilizer nut.
5. Disengage the door glass from the regulator lift plate and position into the full up position.
6. Secure the glass in the up position using a wood wedge or equivalent.
7. Lower the regulator.

Fig. 12:

8. Disconnect the electrical connector. (Fig. 12)
9. Remove the lower regulator bolt and loosen the upper two. (Fig. 12)
10. Slide the regulator up and out of the keyhole slots in the door panel.
11. Remove the regulator through the hole in the inner door panel.

INSTALLATION

1. Install the regulator through the hole in the inner door panel.
2. Position the regulator bolts into the keyhole slots and slide into place.
3. Install the lower regulator bolt and tighten all three to 10 N.m (89 in.lbs).
4. Connect the electrical connector.
5. Position the stabilizer, install the nut and tighten to 10 N.m (89 in.lbs).
6. Raise the regulator to the position shown in (Fig. 11).
7. Remove the glass support and connect to the regulator lift plate.
8. Install the glass nuts and tighten to 10 N.m (89 in.lbs).
9. Disconnect the window switch and install into the door trim panel.
10. Install the waterdam.