Passenger Switch

REMOVAL
1. Disconnect and isolate the battery negative remote cable.
2. Remove passenger door trim panel.
3. Disconnect switch wire connector.
4. Using a trim stick (special tool # C-4755), gently pry out switch from bezel being careful not to damage bezel. First, insert the trim stick into the switch pocket in the flush side to release that side from the pocket. Use only enough force on the trim stick to permit the switch to be released from the pocket, and avoid twisting the stick to prevent damage to the switch or plastic pocket.

Passenger Power Window Switch:

NOTE: The connector is flush with one side of the switch housing.

5. After the flush side is released, release the non-flush side with similar care.

NOTE: Releasing the non-flush side first will make the flush side less accessible requiring extra force to remove.

INSTALLATION
For installation, reverse the above procedures.