Wheel Alignment Setup

NOTE: The Viper front and rear wheel alignment must be checked and or adjusted to the preferred specifications, with the vehicle at Curb Height rather than at Design Height.

1. Correctly position the vehicle on wheel alignment equipment per the equipment manufacturer's recommendations.
2. Perform a pre-wheel alignment inspection. Refer to Pre-Wheel Alignment Inspection.

NOTE: When the front and rear height checking fixture is installed on the wheels, they must be positioned at the very bottom of the wheel inner flange. This is required to ensure the height checking fixtures are parallel to the bottom surface of the frame rails, which is required to achieve an accurate vehicle curb height measurement.

3. Measure the vehicles curb height. Refer to Curb Height Measurement for the proper procedure. Refer to Curb Height And Design Height Specifications for height specifications
4. Attach the wheel alignment equipment following the equipment manufacturer's instructions.
Align the vehicle starting with the rear suspension, then proceeding to the front suspension. Always set toe last.
5. Proceed with Camber And Caster Angle.