Incomplete Latch Release - No Current

Tests 1 - 2:

Tests 3 - 5:

SYMPTOM
INCOMPLETE LATCH RELEASE - NO CURRENT

WHEN MONITORED
Whenever the PSD module is awake and performing a power operation.

SET CONDITION
When the release operation was not completed in 4 seconds and current did not build up to the stall level, this code will set.

POSSIBLE CAUSES
- Cinch/release motor latch driver circuit short to ground
- Cinch/release motor latch driver wire open
- Cinch/release motor unlatch driver wire open
- Latch assembly
- Power sliding door module