Incomplete Latch Release - Ratchet Switch Failure

Tests 1 - 2:

Tests 3 - 6:

SYMPTOM
INCOMPLETE LATCH RELEASE - RATCHET SWITCH FAILURE

WHEN MONITORED
Whenever the power sliding door is operating in an opening direction.

SET CONDITION
The release operation was not completed in 4 seconds or a stall condition was detected in the release operation. The pawl switch was grounded but the ratchet switch remained open. This code will set only in the release operation.

POSSIBLE CAUSES
- DTC present
- Binding door
- Power sliding door module - ratchet circuit
- Ground wire open
- Sliding door ajar switch sense wire open
- Ratchet switch