Handle - Grab

HANDLE - GRAB

REMOVAL

1. Turn headlamp switch to shut off reading lamp.
2. Hold handle downward and remove attaching screws.

Fig. 73:

3. Pull handle inward to release handle clips from sheet metal (Fig. 73).
4. Disconnect wire connector from lamp, if equipped.
5. Remove grab handle from vehicle.

INSTALLATION

Fig. 74:

1. Place grab handle into position (Fig. 74).
2. Connect lamp wire connector, if equipped.
3. Using 2-way locating pins press on grab handle until it snaps into place.
4. Install attaching screws.
5. Tug on handle to insure clips are properly installed.