B-Pillar Lower Trim
B - PILLAR LOWER TRIMREMOVAL
NOTE: The driver's side a double ended stud is used. A nut has to be removed for the seat belt anchor removal and the stud for the retractor removal.
NOTE: On the passenger side there is a belt tension sensor.
1. Slide lower seat belt cover rearward to expose anchor fastener.
2. Remove bolt/nut attaching lower seat belt anchor to floor.
3. Remove upper B-pillar trim cover.
Fig. 3:
4. Remove access panel from B-pillar trim (Fig. 3).
5. Disengage hidden clips attaching lower trim cover to B-pillar.
6. Remove lower B-pillar trim cover from vehicle.
INSTALLATION
NOTE: The driver's side a double ended stud is used. A nut has to be removed for the seat belt anchor removal and the stud for the retractor removal.
NOTE: On the passenger side there is a belt tension sensor.
1. On the passenger side secure grommet to seat belt sensor connector into bottom of B-pillar lower trim prior to install B-pillar lower trim cover.
2. Place lower B-pillar trim cover in position on vehicle (Fig. 3).
3. Insert seat belt through hole in lower B-pillar trim.
4. Engage hidden clips attaching lower trim cover to B-pillar.
5. Install access cover.
6. Install upper B-pillar trim cover.
7. Place seat belt anchor in position on floor so webbing is pointed rearward and slightly outboard.
8. Install bolt/nut attaching lower seat belt anchor to floor. Tighten seat belt anchor bolt/nut to 39 N.m (29 ft.lbs.) torque.
9. Verify that seat belt anchor does not interfere with seat track travel.