Disassembly and Assembly

DISASSEMBLY - ROCKER ARMS AND SHAFT

CAUTION: Do not attempt to drive the bolt from the rocker shaft. This can damage the retainer and bolt assembly.

1. Remove the rocker arm retainer and bolt by performing the following procedure:





a. Using adjustable pliers, grip the edges of the retainer (Fig. 39).
b. Apply an upward force with a slight rocking motion until the retainer disengages from shaft (Fig. 39).





2. Remove rocker arms (Fig. 40). Identify the component locations for reassembly in original locations.

ASSEMBLY - ROCKER ARMS AND SHAFT
1. Install rocker arms on the shaft (Fig. 40). Install in the original positions if re-used. Ensure the rocker shaft, all the retainers and washers are properly positioned and installed in the correct locations (Fig. 40).
2. Install rocker arms and shaft to the cylinder head.