Loss of Ignition Run Only (Stored)

Test 1:

SYMPTOM
LOSS OF IGNITION RUN ONLY - STORED

TEST NOTE
This symptom is diagnosed using the test CLUSTER MESSAGE MISMATCH - STORED.

WHEN MONITORED
With the ignition in the run/start position the ACM monitors the Fused Ignition Switch Output Run/Start circuit for proper system voltage.

SET CONDITION
If the voltage on the Fused Ignition Switch Output Run Only circuit drops below approximately 4.5 volts, the code will set.

POSSIBLE CAUSES
- Active or stored code present
- Stored code or intermittent condition