P1737

P1737 - MS SOLENOID CIRCUIT

When Monitored and Set Condition:
P1737 - MS SOLENOID CIRCUIT

When Monitored: Initially at power-up, then every 10 seconds thereafter. They will also be tested immediately after a gear ratio or pressure switch error is detected.

Set Condition: Three consecutive solenoid continuity test failures, or one failure if test is run in response to a gear ratio or pressure switch error.

POSSIBLE CAUSES:
RELATED RELAY DTC'S PRESENT
INTERMITTENT WIRING & CONNECTORS
MS SOLENOID CONTROL CIRCUIT OPEN
TRANSMISSION RELAY OUTPUT CIRCUIT OPEN
MS SOLENOID CONTROL CIRCUIT SHORT TO GROUND
MS SOLENOID CIRCUIT SHORT TO VOLTAGE
MS SOLENOID INOPERATIVE
TCM - MS SOLENOID CIRCUIT