Rear HVAC Control Replacement

REMOVAL
The rear blower motor switch is integrated into the rear control and is used only on models with the optional rear heater-A/C unit.
1. Disconnect and isolate the battery negative cable.
2. Using a trim stick or another suitable wide fiat-bladed tool, gently pry above the two indentations at the outer perimeter of the rear control to release it from the headliner.
3. Pull the rear blower motor switch away from the headliner far enough to access and unplug the wire harness connector from the back of the switch.
4. Remove the rear blower motor switch from the headliner.

INSTALLATION
The rear blower motor switch is used only on models with the optional rear heating-A/C unit.
1. Plug the wire harness connector into the back of the rear blower motor switch.
2. Tuck the wire harness back through the rear blower motor switch mounting hole in the headliner.
3. Gently press the rear blower motor switch into the mounting hole in the headliner until it snaps into place.
4. Connect the battery negative cable.