Evaporative Emission Control Canister: Service and Repair

Fig. 13 EVAP Canister Location:

REMOVAL
Two EVAP canisters are used. Both canisters are mounted to a bracket located below rear of vehicle cab on outside of right frame rail.
1. Remove fuel tubes/lines at each EVAP canister. Note location of tubes/lines before removal for easier installation.
2. Remove mounting nuts at each canister.
3. Remove each canister from mounting bracket.

INSTALLATION
Two EVAP canisters are used. Both canisters are mounted to a bracket located below rear of vehicle cab on outside of right frame rail.
1. Place each canister to mounting bracket.
2. Install nuts and tighten to 9 Nm (80 in. lbs.) torque.
3. Install fuel tubes/lines to each canister.