Seat - Second Row

SEAT - SECOND ROW - STOW -N-GO

REMOVAL

Fig. 53:

1. Place 2nd row seats in upright position. (Fig. 53)
2. Place special tool # 9313 R1 on seat shaft.

NOTE: Be sure special tool #9313 R1 is firmly seated. Failure to do so could result in injury.

3. Remove seat from vehicle.

INSTALLATION

1. Place second row seat into position in vehicle.
2. Install the three attaching nuts. Tighten nuts to 54 N.m (40 ft.lbs.) torque.
3. Lock seat down on rear strikers.
4. Raise seat to upright position. (Fig. 53)