Recirc Overcurrent (Stored)

Test 1:

SYMPTOM
RECIRC OVERCURRENT (STORED)

TEST NOTE
This symptom is diagnosed using the test A/C SWITCH FAULT (STORED).

WHEN MONITORED
When actuator movement is requested.

SET CONDITION
This DTC will set if the A/C-Heater Control Module detects an excessive current draw on any of the door driver circuits while attempting to drive this actuator. Only one overcurrent DTC can set per ignition cycle.

POSSIBLE CAUSES
- Check for active HVAC DTCs and system test fault messages
- Stored code(s) test complete.