Seat Belt and Retractor - Rear Seat

REMOVAL

WARNING: DURING AND FOLLOWING ANY SEAT BELT SERVICE, CAREFULLY INSPECT ALL SEAT BELTS, BUCKLES, MOUNTING HARDWARE, AND RETRACTORS FOR PROPER INSTALLATION, OPERATION, OR DAMAGE. REPLACE ANY BELT THAT IS CUT, FRAYED, OR TORN. STRAIGHTEN ANY BELT THAT IS TWISTED. TIGHTEN ANY LOOSE FASTENERS. REPLACE ANY BELT THAT HAS A DAMAGED OR INOPERATIVE BUCKLE OR RETRACTOR. REPLACE ANY BELT THAT HAS A BENT OR DAMAGED LATCH PLATE OR ANCHOR PLATE. NEVER ATTEMPT TO REPAIR A SEAT BELT COMPONENT. ALWAYS REPLACE DAMAGED OR FAULTY SEAT BELT COMPONENTS WITH THE CORRECT, NEW AND UNUSED REPLACEMENT PARTS LISTED IN THE MOPAR PARTS CATALOG.

1. Unsnap and remove the rear shoulder belt turning loop cover to access the screw that secures the turning loop to the C-pillar.

Fig.25 Rear Seat Belt & Retractor - Quad Cab:

2. Remove the screw that secures the shoulder belt turning loop to the C-pillar.
3. Remove the shoulder belt turning loop from the C-pillar.
4. Remove the trim from the C-pillar.
5. Remove the screw that secures the lower seat belt anchor plate to the C-pillar.
6. Remove the lower seat belt anchor plate from the C-pillar.
7. Remove the screw that secures the retractor to the C-pillar.
8. Remove the rear shoulder belt and retractor from the C-pillar.

INSTALLATION

WARNING: DURING AND FOLLOWING ANY SEAT BELT SERVICE, CAREFULLY INSPECT ALL SEAT BELTS, BUCKLES, MOUNTING HARDWARE, AND RETRACTORS FOR PROPER INSTALLATION, OPERATION, OR DAMAGE. REPLACE ANY BELT THAT IS CUT, FRAYED, OR TORN. STRAIGHTEN ANY BELT THAT IS TWISTED. TIGHTEN ANY LOOSE FASTENERS. REPLACE ANY BELT THAT HAS A DAMAGED OR INOPERATIVE BUCKLE OR RETRACTOR. REPLACE ANY BELT THAT HAS A BENT OR DAMAGED LATCH PLATE OR ANCHOR PLATE. NEVER ATTEMPT TO REPAIR A SEAT BELT COMPONENT. ALWAYS REPLACE DAMAGED OR FAULTY SEAT BELT COMPONENTS WITH THE CORRECT, NEW AND UNUSED REPLACEMENT PARTS LISTED IN THE MOPAR PARTS CATALOG.

1. Position the retractor onto the C-pillar.
2. Install and tighten the screw that secures the retractor to the C-pillar. Tighten the screw to 40 Nm (29 ft. lbs.).
3. Position the lower seat belt anchor plate onto the C-pillar.
4. Install and tighten the screw that secures the lower seat belt anchor plate to the C-pillar. Tighten the screw to 40 Nm (29 ft. lbs.).
5. Reinstall the trim onto the quarter inner panel (club cab) or the C-pillar (quad cab).
6. Position the shoulder belt turning loop onto the C-pillar.
7. Install and tighten the screw that secures the shoulder belt turning loop to the C-pillar. Tighten the screw to 30 Nm (22 ft. lbs.).
8. Snap the trim cover over the rear shoulder belt turning loop anchor plate to conceal the screw that secures the turning loop to the C-pillar.