Rear Axle - 9 1/4 Inch

9 1/4 Inch - Rear Axle Bearings
REMOVAL
1. Remove axle shaft.






2. Remove axle shaft seal from the end of the axle tube with a small pry bar (Fig. 24).

NOTE: The seal and bearing can be removed at the same time with the bearing removal tool.






3. Remove axle shaft bearing with Bearing Remover 6310 and Foot 6310-9 (Fig. 25).

INSTALLATION
1. Wipe the axle tube bore clean. Remove any old sealer or burrs from the tube.






2. Install axle shaft bearing with Installer C-4198 and Handle C-4171 (Fig. 26). Drive bearing in until tool contacts the axle tube.

NOTE: Bearing is installed with the bearing part number against the installer.

3. Coat the lip of the new axle seal with axle lubricant and install with Installer C-4076-B and Handle C-4735-1.
4. Install the axle shaft.