A/C Heater Control - Front

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the cluster bezel from the instrument panel. Refer to: Instrument Panel, Gauges and Warning Indicators, Instrument Cluster/Carrier, Service and Repair, Instrument Cluster Service Procedures, Instrument Cluster Bezel Replacement, Instrument Cluster Bezel Replacement

Fig.15 A/C Heater Control Remove/Install:

3. Remove the four screws that secure the heater- A/C control to the cluster bezel.
4. Unplug the wire harness connector from the back of the heater-A/C control
5. Remove the heater-A/C control from the instrument panel.

INSTALLATION
1. Plug the wire harness connector into the back of the heater-A/C control.
2. Position the heater-A/C control in the cluster bezel and secure it with four screws. Tighten the screws to 2.2 Nm (17 ± 3 in. lbs.).
3. Reinstall the cluster bezel to the instrument panel. Refer to: Instrument Panel, Gauges and Warning Indicators, Instrument Cluster/Carrier, Service and Repair, Instrument Cluster Service Procedures, Instrument Cluster Bezel Replacement, Instrument Cluster Bezel Replacement

4. Connect the battery negative cable
5. Perform the A/C cool down test using the DRB III.