Instrument Panel Base Trim Replacement

BASE TRIM

REMOVAL

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, SEAT BELT TENSIONER, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

1. Disconnect and isolate the battery negative cable.
2. Remove the instrument panel from the vehicle. Instrument Panel Assembly
3. Place the instrument panel on a suitable work surface. Be certain to take the proper precautions to protect the instrument panel from any possible cosmetic damage.
4. Remove the instrument cluster from the instrument panel. Instrument Cluster Replacement
5. Remove the radio from the instrument panel. Radio, Stereo, and Compact Disc
6. Remove the top cover from the instrument panel. Instrument Panel Top Cover

NOTE: Four of the screws secure the lower instrument panel duct to the base trim.

7. Remove the screws around the perimeter of the instrument panel that secure the base trim to the instrument panel structural support.
8. Remove the base trim from the instrument panel structural support.

INSTALLATION

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, SEAT BELT TENSIONER, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

1. Position the base trim onto the instrument panel structural support.
2. Install and tighten the screws around the perimeter of the instrument panel that secure the base trim to the instrument panel structural support. Tighten the screws to 2 Nm (20 in.lbs).
3. Install the top cover onto the instrument panel. Instrument Panel Top Cover
4. Install the radio into the instrument panel. Radio, Stereo, and Compact Disc
5. Install the instrument cluster into the instrument panel. Instrument Cluster Replacement
6. Install the instrument panel into the vehicle. Instrument Panel Assembly
7. Connect the battery negative cable.