Seat Cushion Cover / Foam - Third Row

SEAT CUSHION COVER / FOAM - THIRD ROW - STOW -N-GO

REMOVAL

NOTE: On leather trimmed seats, cushion cover can be removed from the cushion foam pad. On cloth trimmed seats, the cushion cover does not separate from the foam pad.

1. Remove seat from vehicle.
2. Remove screws fastening rear grocery bag holders.
3. Remove inboard and outboard recliner covers.
4. Using a special tool C-4755, remove pull strap bezel.
5. Unzip both sides of the seat covers.
6. Disengage seat cushion cover J-straps from cushion pan panel.
7. Remove cover and foam from cushion pan panel.

INSTALLATION

NOTE: On leather trimmed seats, cushion cover can be removed from the cushion foam pad. On cloth trimmed seats, the cushion cover does not separate from the foam pad.

1. Place the seat cushion cover and foam together.
2. Route pull strap through the slit on bottom of trim cover.
3. Pull trim cover around corners of frame and secure J-retainers.
4. Zip both sides of seat covers.
5. Fasten screw attaching inboard and outboard recliner covers.
6. Fasten screws attaching rear grocery bag holder.
7. Install seat into vehicle.