Disc Brake Caliper Adapter

REMOVAL - FRONT DISC BRAKE CALIPER ADAPTER
1. Raise vehicle.
2. Remove front wheel and tire assembly, disc brake caliper and brake shoes.
3. Remove two bolts fastening adapter to steering knuckle, then remove disc brake caliper adapter.

INSTALLATION - FRONT DISC BRAKE CALIPER ADAPTER
1. Place adapter over brake rotor and align adapter mounting holes to knuckle.

CAUTION: Adapter mounting bolts have a special Dacromet coating applied to resist corrosion. If mounting bolts need to be replaced, use only leopard replacement parts.

2. Install adapter mounting bolts and tighten to 169 Nm (125 ft. lbs.) torque.
3. Install brake shoes, disc brake caliper and wheel and tire assembly.
4. Lower vehicle.
5. Pump the brake pedal several times to set the pads to the brake rotor.
6. Check and adjust brake fluid level as necessary.