Compressor HVAC: Service and Repair

REMOVAL
1. Recover refrigerant from A/C system.
2. Disconnect negative battery cable and isolate it.

Fig.1 A/C Compressor Lines:

3. Remove refrigerant lines from compressor.

NOTE: Cap lines while system is open to prevent moisture from entering system.

4. Raise and support vehicle.
5. Remove drive belt.
6. Disconnect compressor clutch wire lead.

Fig.2 A/C Compressor Mounting Bolts:

7. Remove four compressor mounting bolts and lower compressor from vehicle.

INSTALLATION

CAUTION: Add only new lubricant when system requires additional lubricant. Do not use old reclaimed lubricant.

1. Position the compressor onto the bracket.
2. Install the compressor mounting bolts.
3. Remove protective caps if installed.
4. Install the compressor refrigerant lines.
5. Connect the compressor wire connector.
6. Install the drive belts.
7. Connect the battery negative cable.
8. Tighten the compressor mounting bolts to 28 Nm (250 in. lbs).
9. Tighten the compressor lines to 12 Nm (108 in. lbs).
10. Evacuate the refrigerant system.
11. Recharge the A/C system if needed.