Rear Axle - 248RBI
Rear Axle - 248RBIREMOVAL
1. Raise and support the vehicle.
2. Position an axle lift under the axle and secure it to the axle.
3. Remove the wheels and tires.
4. Remove RWAL sensor from the differential housing, if necessary.
5. Remove brake hose from the axle junction block.
6. Disconnect parking brake cables and cable brackets.
7. Remove vent hose from the axle shaft tube.
8. Mark propeller shaft and yoke for installation alignment reference.
9. Remove propeller shaft.
10. Remove shock absorbers from the axle brackets.
11. Remove spring clamps and spring brackets.
12. Remove axle from the vehicle.
INSTALLATION
1. Raise axle with lift and align to the leaf spring centering bolts.
2. Install spring clamps and spring brackets.
3. Install shock absorbers and tighten to specifications.
4. Install RWAL sensor to the differential housing, if necessary.
5. Install parking brake cables and cable brackets
6. Install brake hose to the axle junction block.
7. Install axle vent hose.
8. Install propeller shaft with reference marks aligned.
9. Install wheels and tires assemblies.
10. Add gear lubricant, if necessary.
11. Remove lift from the axle and lower the vehicle.