Window Regulator - Manual

WINDOW REGULATOR - MANUAL

REMOVAL

1. Remove the waterdam. Refer to front door panel.

Fig. 14:

2. Reinstall the window handle and raise the window to the position shown and remove the nuts. (Fig. 14)
3. Disengage the door glass from the regulator lift plate and position into the full up position.
4. Secure the glass in the up position using a wood wedge or equivalent.
5. Lower the regulator.
6. Remove the stabilizer nuts.

Fig. 16:

7. Remove the two lower and loosen the two upper bolts. (Fig. 16)
8. Slide the regulator up and out of the keyhole slot.
9. Remove the regulator from the door panel opening.

INSTALLATION

1. Install the regulator through the hole in the inner door panel.
2. Position the regulator and slide the upper bolts into the keyhole slots.
3. Install the lower two bolts.
4. Tighten the regulator bolts to 10 N.m (89 in.lbs).
5. Position the stabilizer, install the nuts and tighten to 10 N.m (89 in.lbs).
6. Using the window handle raise the regulator to the position shown in (Fig. 14).
7. Remove the glass support and connect to the regulator lift plate.
8. Install the glass nuts and tighten to 10 N.m (89 in.lbs).
9. Remove the window handle and install the waterdam.