Operation CHARM: Car repair manuals for everyone.

Front Seat

SEAT-FRONT

REMOVAL

NOTE: Do not reuse the seat fasteners, always replace with new ones.

Fig. 12:




1. Remove and discard the front bolts. (Fig. 12)
2. Position the seats forward, remove the rear bolts and discard.

Fig. 13:




3. Disconnect the 12v power supply electrical connector, if equipped. (Fig. 13)
4. Fold the seat backs forward and roll the seat assembly back in the vehicle.

Fig. 14:




5. Separate the seat assembly by removing and discarding the three nuts on either the drivers or passengers seat. (Fig. 14)
6. Remove each section of the seat assembly from the vehicle.

INSTALLATION

NOTE: Do not reuse the seat fasteners, always replace with new ones.

1. Position each seat section into the vehicle and tip back.
2. Install the three nuts attaching the center seat section to the other seat, and tighten to 25 N.m (18 ft.lbs).
3. Roll the seat assembly forward and install new rear bolts.
4. Connect the 12v power supply electrical connector.
5. Tighten the rear bolts to 40 N.m (30 ft.lbs).
6. Fold the seat backs up and slide the seats to the rear.
7. Install new front bolts and tighten to 28 N.m (21 ft.lbs).