Oxygen Sensor: Service and Repair

REMOVAL

Fig.23 O2S Sensor Location - 2 Sensor System:

Fig.24 O2S Sensor Location - 4 Sensor System:

If equipped with a 2-O2 sensor system, the sensors are located at the inlet and outlet ends of catalytic converter. If equipped with a 4-O2 sensor system, the sensors are located before and after the mini-cats.

Never apply any type of grease to the oxygen sensor electrical connector, or attempt any soldering of the sensor wiring harness.

WARNING: THE EXHAUST MANIFOLD, EXHAUST PIPES AND CATALYTIC CONVERTER BECOME VERY HOT DURING ENGINE OPERATION. ALLOW ENGINE TO COOL BEFORE REMOVING OXYGEN SENSOR.

1. Raise and support vehicle.
2. Disconnect wire connector from O2 sensor.

CAUTION: When disconnecting sensor electrical connector, do not pull directly on wire going into sensor.

3. Remove O2 sensor using an oxygen sensor removal/installation tool.

INSTALLATION
If equipped with a 2-O2S sensor system, the sensors are located at the inlet and outlet ends of catalytic converter. If equipped with a 4-O2 sensor system, the sensors are located before and after the mini-cats.

Threads of new oxygen sensors are factory coated with anti-seize compound to aid in removal. DO NOT add any additional anti-seize compound to the threads of a new oxygen sensor.
1. Install O2S sensor. Tighten to 30 Nm (22 ft. lbs.) torque.
2. Connect O2S sensor wire connector.
3. Lower vehicle.